anyone know the torque specs for the rear axle nuts on my 695? or is it "T" for tight?
Quote from: calscrazy on September 30, 2008, 05:11:31 PM
anyone know the torque specs for the rear axle nuts on my 695? or is it "T" for tight?
i think the torque specs on the SS were about 83Nm (22mm?). the M750 was about the same.
Quote from: ♣ McKraut ♣ on September 30, 2008, 05:19:04 PM
i think the torque specs on the SS were about 83Nm (22mm?). the M750 was about the same.
greased threads and 83Nm is what's been posted before in the tech section
yeah, don't forget the lube
Quote from: Ronr link=topic= 12308.msg210887#msg210887 date=1222826304
That's what she said
very nice 8)
Chris,
The following is lifted from the owner's manual of a 2007 Ducati Monster 695, page 50, last paragraph. The section in the Manual was regarding "Tensioning the drive chain".
Grease the thread of the axle nut (1) with SHELL
Retinax HDX2 and tighten to a torque of 72 Nm.
Grease the threads of the adjuster screws (2) with
SHELL Alvania R3 an tighten to a torque of 8 Nm.
If it is not in your Manual, download the pdf file from
http://www.ducati.com/en/bikes/service/manuals/2007.jhtml?family=manuals
cdc
or just tighten that pregnant dog up....i'm just sayin'.
right side no prob. left side just spins along with axle. even if i put the right side back on the left side just spins. i think tomm i will try the old double nut trick. this is really startn to test my patience!!! [bang] [bang]
Any luck?!?