Ducati Monster Forum

I can figure out the clutch side but how about the throttle side? I managed to undo the throttle cable so the grip and "tube" aren't under tension of the cable. Do I just pry something between the factory grip and throttle tube and separate them? I just don't want to mess anything up especially when it comes to controls.

Thanks

they basically swap the same... lil'bit of rubbing alcohol will loosen the grip and it should slide right off. just find something you can lift the grip away w/ and spray... like a scribe, or a pick, etc.

Compressed air. Slide the nozzle under the grip and shoot the air inside. The grip will balloon up and just pull it right off. No need to take anything apart.

Slice it lengthwise with a razor blade

Long screwdriver, get it between grip & throttle tube, go all the way round the tube with the screwdriver in between, working grip off as you go...

I just did mine the other night... pryed it up a bit with a screwdriver, sprayed in some hair spray (perfect lubricant/adhesive) worked it around to the rest of the grip, then it slid right off.  I gave the new grips a spritz on the inside to slide back on.  Easy as pie.

Thanks guys. Just wanted to be sure...  [thumbsup]

Thanks again for the help. I just threw on some free-to-me Driven gel grips. While they are soft, the throttle side doesn't completely cover the flared end of the tube. What grips  are on the market that cover it up? I like the feel of the Driven gel grips but hate how it looks.

the progrips I've got cover them

Any particular model?

after a quick bit of googlin'

http://www.motorcycle-superstore.com/1/4/68/4511/ITEM/Pro-Grip-780-Sportbike-Race-Grip.aspx (http://www.motorcycle-superstore.com/1/4/68/4511/ITEM/Pro-Grip-780-Sportbike-Race-Grip.aspx)

iirc, most sportbike grips should have the cutout to fit over the inner end of the throttle. you'll also want the open-ended kind

I ended up ordering these.. http://www.motorcycle-superstore.com/1/4/68/4489/ITEM/Pro-Grip-699-Open-End-Sportbike-Gel-Grip.aspx

I'll let you know how they work out when I get them on Tuesday.  8)

Holy dead thread resurrection, Batman!

The advice in this thread was spot on as far as stripping and mounting... the only downside is getting my Napolean bar-ends lined back up.  Royal PITA until I retrieve the one washer that scooted off under the water heater during removal, but not in any way related to what the DMF'ers shared about grip fixing.

I'm trying out Ariete grips on the recommendation of a local long-haul sport-tourer type.  I didn't get to take a spin with them attached 'cuz yard work got in the way, so I'l post pics and a review soon.

Hey, do the 699's fit over the inner side of the throttle?

Unfortunately no. It gets super close though. What I ended up doing a while back was painting the throttle tube black to mask it as much as I could.

(http://i25.tinypic.com/116hrtf.jpg)

Thanks.  Darn.