|
Title: anyone know or recommend an aluminum welder for a super small job? Post by: Labbedds on May 11, 2008, 04:45:23 PM Thanks
Title: Re: anyone know or recommend an aluminum welder for a super small job? Post by: Vindingo on May 11, 2008, 06:00:51 PM brake lever didnt work?
Title: Re: anyone know or recommend an aluminum welder for a super small job? Post by: enzo on May 11, 2008, 06:23:23 PM Try Dennis at Norman Racing in Berkeley. He's done lot's of little things for me. Great guy, too. He does a lot of work for Desmoto and Monroe's as well.
Title: Re: anyone know or recommend an aluminum welder for a super small job? Post by: Labbedds on May 11, 2008, 06:28:29 PM Haven't tried it but want a backup plan just in case. The moto is my only transportation so if I can't get it to work I need to take it somewhere asap. Stuck in the library i hate my life [coffee] Thanks Vindango for your donation if I can't use it I'll promptly return it to you.
Title: Re: anyone know or recommend an aluminum welder for a super small job? Post by: duckwrench13 on May 11, 2008, 08:07:21 PM It's a cast aluminum part, so welding may do more damage than fixing. It may also cost you just as much as a new lever. Besides, it's only the rear brake... you don't need it anyways. [cheeky]
I'll dig trhough my "junk" and see if I have something. [thumbsup] Title: Re: anyone know or recommend an aluminum welder for a super small job? Post by: Labbedds on May 11, 2008, 08:11:44 PM I don't need the rear brake unless I get stuck on one of the 3 hills to school in the morning a.k.a. webster or fillmore. Kinda hard to stop with the front and get power again. Ugh. [bang]
|