how do you install ignitech sparker on a 2000 m750? i cannot figuire out which cables go to which coil. any help would be greatly appreciated.
thanks
On mine, the pickup cables had black or white protection (the 2wire pair from alt cover).
So white to white & black to black and connect the 3wire coil cable
from the old ign module the same:
The module w white wired pu gets the white 3wire connection from Ignitech.
on mine, the cable colors are throttle side are black/grey/red the other side is black/browngreen/red. ignitech cables are white connector one white wire, black one has red/orange/blue? :-\
Forget the Ignitech wiring colours,
just read & follow my directions regarding the plastic connectors,
just follow black & white.
The 2 pairs of wires from Left side of engine, what colour is the shield/wrapping of them?
A pic would be helpful. :)
ok images included
(http://i266.photobucket.com/albums/ii256/dasmurder/002.jpg)
(http://i266.photobucket.com/albums/ii256/dasmurder/001.jpg)
If the first pic duo, 1 x 2 wires fr pu + 1 x 3 wires to coil, were on the same org ign module
and it`s the same in pic 2, they were on same module, you`ve got it right.
The black or white pu protection I mentioned you see in pic, black around the pu wires.
cool, thanks for all your help ;D
No problemo, ;)
all is working good now?
started the sucker up and...... nothing but back firing. will not run grrrr. i took the unit out plugged it up to pc and the software gives me not connected to pc? so i cannot chech if its setup correctly [bang] damn, bike.
Was the key on when you plugged in? The unit needs to be powered up to communicate.