so my bike is finally being delivered, tomorrow at 9 in the morning, after waiting 2 weeks. so i have most of my new parts sitting and waiting to be installed. i read on here that the torque specs for the pressure plate are 7nM is this correct, and the other question is i am removing bar risers and returning it to the stock position till i decide what clip-ons i want, what is the torque specs on the four bolts for the stock handle bars? thanks
Quote from: tilt on May 11, 2009, 04:19:28 PM
i read on here that the torque specs for the pressure plate are 7nM is this correct, and the other question is i am removing bar risers and returning it to the stock position till i decide what clip-ons i want, what is the torque specs on the four bolts for the stock handle bars? thanks
Yes - for a dry clutch pressure plate - the spring retainer bolts are 7Nm
Handle bard bolts? It's probably around 17Nm... but hand tight with some medium loc tite and they will be fine. YOu don't need to be super specific on items like those and long as you don't go Gorilla on them.