I need to put a new master link on the SS track bike and I'd like to do it right.
However, I don't want to buy a chain tool that might get used every few years at best.
If any of you good DMF'ers would be kind enough to loan me your chain press/riveter, not only do I promise to ship it back to you, I'll refund you whatever it cost to ship it to me in the first place *and* I'll include some other goodies.
Any takers?
I need to have this done before the 30th. First trackday May 31. 8)
Anyone?
i HIGHLY recommend you buy the DID clone, its only $25 and will do everything you need to do include break.
http://www.mikesxs.net/products-49.html#products (http://www.mikesxs.net/products-49.html#products)
search drive chain tool. requires 2 spanners to operate.
Where are you located? If you are in So Cal, I'll change it for you.
Quote from: He Man on May 20, 2009, 11:02:40 PM
i HIGHLY recommend you buy the DID clone, its only $25 and will do everything you need to do include break.
http://www.mikesxs.net/products-49.html#products (http://www.mikesxs.net/products-49.html#products)
search drive chain tool. requires 2 spanners to operate.
That fiber optic scope looks cool.
Quote from: silentbob on May 20, 2009, 11:05:53 PM
Where are you located? If you are in So Cal, I'll change it for you.
He lives "just inside the gates of hell" so he must be in Bakersfield. ;D
[laugh]
No, even the devil won't go there [evil]
If the DID clone is only $25 I'll just get it. I though these tools were $100ish
Ok...
I bought the riveter, the press, the breaker and an extra rivet pin
[thumbsup]
Quote from: erkishhorde on May 20, 2009, 11:12:48 PM
He lives "just inside the gates of hell" so he must be in Bakersfield. ;D
nope...hell moved years ago. it's now up in Redding, my ex runs it.