Does anyone know off hand what the minimum clutch disk thickness spec is for an S4? I did a few searches an had no results.
What manufacturer? I think it varies from on producer to the next
Thickness does vary.
If the plates have friction material on them, it's the stack height that's important.
The last ones I put a vernier on were about .0128 - .0135 or a little fatter.
I've put together a clutch pack of used plates by looking for plates of were of about that thickness or better it I could find em - old red Barnett's. Worked fine for a while.
LA
According to the S4 service manual, 2.8mm minimum.
Thanks much. I'm trying to figure out where things are at.
I haven't purchased a service manual yet, but it looks like it's about time.