Print Page - Change to 14 tooth on my 696

Title: Change to 14 tooth on my 696
Post by: DucinKtown on July 16, 2009, 07:34:44 PM

Hi all,

I have the stuff to do this on Saturday, but have to buy the socket for the rear nut on the swing arm, I thought it was 25 MM, but nope bigger, by a bit.

To help save me running back to the store any more times than needed, does anyone know the socket i need to get???

If anyone that has done this and has any advise, please and thanks.

Russ

Title: Re: Change to 14 tooth on my 696
Post by: ungeheuer on July 17, 2009, 03:33:36 AM

Mate, its a 30mm socket you'll need.

Title: Re: Change to 14 tooth on my 696
Post by: z0mb1e_DUC on July 17, 2009, 03:36:26 AM

I believe the axle itself is 25mm, which would entail a nut that would be larger.

Title: Re: Change to 14 tooth on my 696
Post by: ungeheuer on July 17, 2009, 04:07:10 AM

Quote from: z0mb1e_DUC on July 17, 2009, 03:36:26 AM
I believe the axle itself is 25mm, which would entail a nut that would be larger.

Well spotted ;)

Title: Re: Change to 14 tooth on my 696
Post by: DucinKtown on July 17, 2009, 06:00:13 AM

Thanks, I found the 25 MM size, bought that one already, oppps too small,

I'll be grabbing the 30 MM, socket today, tomorrows the change.

Thanks Eh!,

Russ

Title: Re: Change to 14 tooth on my 696
Post by: z0mb1e_DUC on July 17, 2009, 02:03:38 PM

Quote from: ungeheuer on July 17, 2009, 04:07:10 AM
Well spotted ;)

Yes, consider me the master of the obvious ;D

Title: Re: Change to 14 tooth on my 696
Post by: DucinKtown on July 19, 2009, 10:56:15 AM

All installed, doing a rip after lunch, I'll tell you what it feels like after.

Thanks For all the help!!!

Russ

Ducati Monster Forum

Moto Board => Tech => Topic started by: DucinKtown on July 16, 2009, 07:34:44 PM