Pretty much like the topic says. I went to adjust the chain today and go though the bike to check every bolt...... Rear wheel is .5mm at most away from touching the rear swingarm. I could clearance the swingarm I suppose, but would rather space the rear wheel out 3mm or so. Right now it could work if I adjusted the eccentric all the way forward and to the top..... But that isn't going to do anything for the handling of the bike.
I do have a lathe, but I'm not sure how you could part off a circle 3mm thick and have no runiut in it unless you could mill it flat?!?
Cut one out of 1/8" sheet. ;)
That'll be way flatter than you could likely do on a lathe.
Can I REALLY be that dumb. Maybe my wife is right, perhaps I overthink everything.
Now, on the drive pins....would I need to make new ones, or just get a longer fastener and fasten them through the spacer?
Oh, and this is where I was yesterday:
(http://i3.photobucket.com/albums/y54/TheoAftonomos/Alexis/photo.jpg)
Came home tonight. 7lbs 12 ounces of trouble in the future!
PM sent. I have one available....
Quote from: TAftonomos on November 14, 2009, 02:44:58 PM
Can I REALLY be that dumb. Maybe my wife is right, perhaps I overthink everything.
Now, on the drive pins....would I need to make new ones, or just get a longer fastener and fasten them through the spacer?
Oh, and this is where I was yesterday:
(http://i3.photobucket.com/albums/y54/TheoAftonomos/Alexis/photo.jpg)
Came home tonight. 7lbs 12 ounces of trouble in the future!
CONGRATULATIONS
congrats man!
Congratulations Dad! [thumbsup]