04 620 replaced the clutch slave and now i can't get the clutch to disengage when the lever is pulled in.
I've tried bleeding it and all I get is fluid coming out, no bubbles.
Tried all the tips in the evoluzione "instructions" to no avail.
Any suggestions?
Did you pre-fill the slave?
I couldn't do it without making a bloody mess so here's what I did:
attached clutch line with assembled slave, but did not install on bike.
filled reservoir and repeatedly squeezed lever until piston was almost flush with the end of the body.
sealed reservoir.
bolted on slave, using bolt tension to evenly snug up the body to the engine.
uncapped reservoir, bled as normal (or tried at least).
No change. up on the rear stand, i put it in gear, pull in the clutch and the tire still spins.
Quote from: Privateer on February 13, 2010, 06:08:39 PM
...up on the rear stand, i put it in gear, pull in the clutch and the tire still spins.
Are you basing your whole issue on the above statement?,...because that's normal.
Clutch plates are dragging and spinning the wheel, but is not noticeable if there's a load on the drivetrain (off thestand).
Quote from: DarkStaR on February 14, 2010, 04:33:22 AM
Are you basing your whole issue on the above statement?,...because that's normal.
Clutch plates are dragging and spinning the wheel, but is not noticeable if there's a load on the drivetrain (off thestand).
Depends on how fast it's spinning. He didn't quantify the speed of the spin so it's hard to say.
hmm here again is where my own ignorance shows. I suppose between the wheel spinning when it's on the stand and the lever feeling like mush made me think it wasn't functioning correctly.
edit: looks like I had it right the whole time, I just didn't know. That or strapping the clutch lever overnight helped.
Thanks for the help and lesson learned.
went for a ride and everything seems fine. the engagement zone of the pull was a little close to the bars so I screwed in the adjuster and it seems good to go now.
thanks again, everyone. I'm kind of newb at this so I appreciate everyone's advice and patience.
Quote from: Privateer on February 14, 2010, 03:18:26 PM
went for a ride and everything seems fine. the engagement zone of the pull was a little close to the bars so I screwed in the adjuster and it seems good to go now.
thanks again, everyone. I'm kind of newb at this so I appreciate everyone's advice and patience.
That screw is not a lever adjuster.
That screw controls piston travel and is used to make sure fluid returns to the reservoir. If you have it in too far your clutch will slip as the bike warms up.