I removed my oil cooler and there was minimal drainage, I poured a majority of the remaining oil back into the reservoir. My question is, when i reinstall do I need to refill the cooler or can I just reconnect and go? My concern is pushing the air back into the motor and causing harm.
Thanks.
Ben
Just connect it back up, I did that when I took mine off to replace the Hoses (Switched to the Hypermotard lines)
I have seen a few others do the same with no problems.
I assume most off the oil will move back down the lines when the engine shuts off anyway, when I disconnected mine I only got a small
amount of oil out also.
Thats what I wanted to hear. Thanks.....
Only takes a second or five to move that much oil through the cooler and lines. Just don't rev the motor until the oil pressure light goes out and you'll do fine.