Looking at a reasonably priced belly pan for a 620, but need to know if it would fit a S2R8.
hmmm. it should techinically bolt on, but you might have clearance issues with the udder?
Gots no udder, using Zards, so no worries there.
the motors are pretty much exactly the same... so i don't see why it wouldn't fit. normally everything listed for a 620/750/800 also fits the S2R800 if it's not swing-arm related... i think... i know my belt covers from Shift-Tech are for a 620/750/800
The only fitment issue could be where the exhaust comes out from under the engine on the s2r... Other than that, it will fit.
Whoah! It's like Stu never left! [thumbsup]
If the kid selling it would get back to me, I'll arrange a visit with the bike to verify.
Thanks all!
I had problems with a CF Monza bellypan I ordered from Monsterparts a couple of years ago, interference with the kickstand assembly. I Dremeled it into compliance however. I suspect it's a Chinese carbon part, not pre-preg like quality carbon should be, with resulting hit-or-miss fitment.