I searched and found older threads on the Badlands flasher unit sold by Cal Cycleworks. I followed the install procedures that have been worked out by forum members (given here http://ducatimonsterforum.org/index.php?topic=28939.0 (http://ducatimonsterforum.org/index.php?topic=28939.0) ). But to my disappointment I have a different problem. After the install, and even before I wired in the diodes, the taillight/turn signal unit worked perfectly with the flasher but the front lamps did not flash. Hmmm. Following putting in diodes nothing changed. I have OEM lamps on the front so I switched in a LED light in the front and no change. Any ideas, theories, or concepts would be greatly appreciated. [bow_down]
Hmm, interesting. Obviously that was my thread - and i had no problems when following the steps from that thread.
Have you tried disabling the integrated unit in the back and trying some flavor of light connected the original way? I'm assuming you're using some sort of integrator tail light. Right?
YUU, Thanks for answering. I'll give disconnecting the tail light/flasher unit and see if the front signals then begin working.