Can't search on my phone
Anyone have the hose fitting dims for the factory hoses? AN? I don't rem.
PLS don't post a link its a bith browsing on a bb
Quote from: ducatiz on June 01, 2010, 04:30:10 AM
Can't search on my phone
Anyone have the hose fitting dims for the factory hoses? AN? I don't rem.
PLS don't post a link its a bith browsing on a bb
AN-6
M14x1.5 thread into both the engine and cooler.
So which is it
I am at the hose counter
You'll need both.
4x M14x1.5 to AN-6
and all the AN-6 fittings and hoses to connect between.
Quote from: DarkStaR on June 01, 2010, 05:23:36 AM
You'll need both.
4x M14x1.5 to AN-6
and all the AN-6 fittings and hoses to connect between.
+1
Aha
Cause the hose guy will swage M14 right onto the hose.
Second question is there any problem with using a banjo/banjo bolt setup instead of the str8 setup?
I am relocating a cooler and could use the clearance
So long as you have the proper crush washers and some crush to keep them in place and tight... No problem.