Made this over the weekend. I got evo-tech fender eliminator w/o any instruction (altho it's supposedly sux to begin with anyway). So was making my way thru figuring out how to install it and made a short video. Hope this can be of help to some ppl out there. Should be identical for 796 and 1100:
M696 Fender Eliminator (http://www.youtube.com/watch?v=ITw0Wc4qMjA#normal)
[clap]
Nice Job!
Thanks for the great vid [clap]
BTW... for the turn signals
"DX" is right (destra in Italian)
"SX" is left (sinistra)
Way to figure it out! [beer]
ppl like u make this forum great.
[thumbsup] [beer]
Cool video - thanks! Glad the is no cutting involved with the M696!
how in the world did you get those screws off? mine are on so tight i twisted my hex bit.
my kit came with instructions. if you need those instructions, PM me.
it's not necessary to remove the entire tail, but I can see how it makes it easier.
also the stock holes on the plate mount are positioned incorrectly for U.S. plates. my kit included plate adapters.
Thank you for uploading this video. This is really helpful.
Thank for making the video. You have a skill at making these vidoes. Just ordered my self the same evotech eliminator as well. Have you considered making a video on how to install Frame Sliders? It would very much appreciated.
Thanks again.....
[thumbsup]