Ducati Monster Forum

earlier this year I bought an '06 S2R1k that already had Speedymoto risers on it.  I think it has these: http://www.speedymoto.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=03-0220BLK&Category_Code=MTC (http://www.speedymoto.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=03-0220BLK&Category_Code=MTC)

for aesthetic reasons, I want to try putting the bars back to stock height.  what parts do I need to accomplish this?

based on the pic below, I think I need a stock lower clamp (5) and possibly upper clamp (1) and of course the associated bolts.  am I right?  or could I use the black speedymoto top cap and just get a stock lower clamp? 

and if these are in fact the stock parts I need, is there a vendor that sells them (haven't been able to find one) or do I just need to buy used from someone who's taken them off their bike?

note: both triple clamps are still stock. 

thanks in advance guys!!

(http://lh6.ggpht.com/_kdcKyMEZ4NM/TG7rFjxFfNI/AAAAAAAAFOc/nY6kvKt0wwA/Bars.jpg)

You can use the SpeedyMoto top cap. No need to buy (1)

Yes, you need two (5)s and shorter bolts. 20mm shorter. Which means M8 x 70
I can't imagine you'd have to pay very much for either if you find them used.
Bought at a Ducati dealer a pair of (5)s cost $54 and a pair of those bolts $4.

thanks stopintime!!

just remove the bolts, put the bars at the stock height, flip the risers, lay on top of bars, put the caps on then the bolts. Problem solved.  [thumbsup]