Print Page - 1100bar end size?

Title: 1100bar end size?
Post by: Frustration on February 02, 2011, 10:28:27 AM

My hyper bars were an off size, not sure about monsters...

Will standard 7/8 inch bar ends etc plug in to the 1100 bars well?

Title: Re: 1100bar end size?
Post by: stopintime on February 02, 2011, 10:32:40 AM

Usually, the steel bars (696?) which aren't tapered are larger inner diameter than the aluminum tapered bars (14mm ID).
Some bar ends will fit both because they are delivered with more than one insert. Best to ask the seller first. If they don't know - look elsewhere?

Title: Re: 1100bar end size?
Post by: Frustration on February 02, 2011, 10:35:17 AM

[coffee]My prob is I don't have the bike yet and can't reach the seller of the bar ends... Hoping someone knows...

Title: Re: 1100bar end size?
Post by: JEFF_H on February 02, 2011, 11:49:14 AM

(according to rhinomoto)
their M1100 bar ends are-

.525" to .575" (13.5mm to 14.6mm)

Title: Re: 1100bar end size?
Post by: Nads on February 02, 2011, 08:00:45 PM

Hiya Frustration

I have a replacement bar end in my hand and measuring rather crudely with a dodgy office ruler it appears to be just over 14mm, certainly under 15mm.

Regards Nads

Ducati Monster Forum

Moto Board => Accessories & Mods => Topic started by: Frustration on February 02, 2011, 10:28:27 AM