hello all...
i am heavily customizing a 96 Bimota that has a 96' Monster 900 engine....it also has 3 spoke marchesini forged aluminum wheels...i am wondering if they are the same spec as monster wheels so i can possible change them to something different...i am first looking for inside of rotor to inside of rotor dimension on front wheel and inside of sprocket to inside of rotor on rear wheel....from this dimension i can determine if they are close.....if yo uhave more dimensions by all means let me have them pleas....but bearing diameter and center spacing can all be determined later...if the above 2 dimensions are larger than what i have currently the swap will be difficult...
thanks
Tony
analogmotorcycles.com
I have a 96 Monster.
Can you use assembled measurements?
Posting to remember. I should have them all in a few hrs for you.
Quote from: avizpls on January 22, 2012, 08:27:12 AM
Posting to remember. I should have them all in a few hrs for you.
Cool...
I won't have to go out in to the freezing barn... ;D
hours go fast where I live.
I measured these with no rotors, no sprockets. so the measurements are from the mounting faces for the rotors and sprockets. I think thats what you wanted, right?
Front wheel:
Front
- width: 104.95mm
- Bearing ID: 20.0mm
- Bearing OD: 47.0mm
Rear
- width: 153.05mm
- Bearing ID: ~17mm
- Bearing OD: ~40mm
The wheels are off, stripped, and in my cozy warm garage if you need anything else?
perfect thanks for all the help guys!!! [thumbsup]
If your monster wheels will fit then obviously the bimota will fit a monster. If that's the case and you're not keeping them, let me know :)