|
Title: streetfighter front end Post by: wannabfast on May 10, 2012, 08:16:46 PM i got a 796 and i sort of want to swap my front end(headlights gauges, bars, forks) from a streetfighter
now, does anyone know the pinout on the gauges from the streetfighter? i like how everything is integrated anyhoo, i figure at minimum the upper triple, lower triple, headlight and gauges, but im not sure if the gauges will plug into the monster harness Title: Re: streetfighter front end Post by: gatorgrizz27 on May 18, 2012, 11:34:31 AM Gauges are never going to work. Its not just wiring them in, aside from the immobilizer issue the streetfighter dash has its own integrated ECM which runs all of the functions controlled by the handlebar switches. In addition the speedo and such as well as many of the engine sensors tie into the dash before running to the ECU. I have completed a lot of projects that people have said were too difficult or not worth it but that dash swap is much more than just re-wiring it.
Headlight should be easy enough though [thumbsup] Title: Re: streetfighter front end Post by: wannabfast on May 18, 2012, 09:45:55 PM well the issue is that the streetfighter gauges are attached to the headlight
Title: Re: streetfighter front end Post by: ungeheuer on May 19, 2012, 03:33:34 AM well the issue is that the streetfighter gauges are attached to the headlight from what gatorgrizz27 had to say, I'm thinking the issue is that..... its never gonna work. Title: Re: streetfighter front end Post by: wannabfast on May 19, 2012, 03:15:02 PM well i suppose i would probably have to get something fabbed up to fit if i chose to go that route [bang]
|