|
Title: Stubby exhaust? anyone used one of these?? Post by: RRossi on May 12, 2012, 09:33:42 PM Looking to do somthing with my stock cored cans as I need a change and want to clean the look up on my m1000, was thinking these but am unsure? http://www.ebay.com.au/itm/170690126847?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 (http://www.ebay.com.au/itm/170690126847?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649) if anyone has any thoughts I would love to hear from you :) RR Title: Re: Stubby exhaust? anyone used one of these?? Post by: seanster on May 12, 2012, 09:36:31 PM Was thinking about to but others convinced me not to go that route
Title: Re: Stubby exhaust? anyone used one of these?? Post by: Timmy Tucker on May 13, 2012, 06:08:09 AM Was thinking about to but others convinced me not to go that route I'm interested in these as well. What was the reason you didn't go with 'em? Title: Re: Stubby exhaust? anyone used one of these?? Post by: seanster on May 13, 2012, 07:03:58 AM I'm interested in these as well. What was the reason you didn't go with 'em? first off it was the noise level...but I have D&D, so not much of a difference. Others telling me that it similar to you just taking off your mufflers and run straight pipe, which in turn not good for your engine due to pressure and lost of power...I'm not exhaust guru or expert, but it make sense when think of it. I'm still waiting for someone with experience with this that convince me to go with this stubby. Title: Re: Stubby exhaust? anyone used one of these?? Post by: wannabfast on May 13, 2012, 07:28:15 AM i wouldnt pay that much for $15 worth of exhaust piping you can get at the local car parts store...
might as well run open pipes however running open pipes you can potentially burn your exhaust valves because the burning exhaust gases will escape faster than they finish burning backpressure = torque and torque = feeling faster but the point is to slow the exhaust gases down enough to do a full burn Title: Re: Stubby exhaust? anyone used one of these?? Post by: xcaptainxbloodx on May 13, 2012, 07:39:24 AM [thumbsdown]
its the motorcycle equivalent when highschool kids put a fart can on a honda. Title: Re: Stubby exhaust? anyone used one of these?? Post by: wannabfast on May 13, 2012, 10:02:11 AM [thumbsdown] tell that to all the harley guys.... [coffee]its the motorcycle equivalent when highschool kids put a fart can on a honda. Title: Re: Stubby exhaust? anyone used one of these?? Post by: xcaptainxbloodx on May 13, 2012, 12:29:46 PM tell that to all the harley guys.... [coffee] is this a defense or an agreement? Title: Re: Stubby exhaust? anyone used one of these?? Post by: wannabfast on May 13, 2012, 05:33:13 PM im agreeing with the motion that its like a fart can for the hondas
Title: Re: Stubby exhaust? anyone used one of these?? Post by: Dirty Duc on May 15, 2012, 11:34:00 AM i wouldnt pay that much for $15 worth of exhaust piping you can get at the local car parts store... might as well run open pipes exactly! however running open pipes you can potentially burn your exhaust valves because the burning exhaust gases will escape faster than they finish burning backpressure = torque and torque = feeling faster but the point is to slow the exhaust gases down enough to do a full burn not exactly... [leo] significantly changing the flow of air through the motor (cams, exhaust, intake, compression) will result in a change in fuel requirements. too lean = higher combustion temps = burnt valves or pistons too rich = deposits = hot spots = burnt valves or pistons "Backpressure" is always bad for performance, because it limits the amount of air the engine can pump to something less than the cylinder's full capacity. That said, reducing "backpressure" without appropriate changes to the rest of the equation will tend to lean out the fuel mixture. This topic is fairly complex, discussions of "backpressure" oversimplify the equations. |