I'm modifying a s4rs a little more along my taste, which involves a lot more taking off than putting on. As you can see I'm still in the ugly mockup stage, but it does crank and run. Basically, I'm using a 996 tank, moving the battery/ecu/relays under the seat,And adding 2 stacked projector lights and a motogadget tach up front.
There are 2 wires from the ecu I can't id, blue/yellow body connector pin 13 and orange/blue body connector 7. Both went to the dash, but I at a loss as to their purpose. My led for low fuel stays on all the time and I can't get the stock oil pressure sender to register. I have a motogadget oil pressure sender coming, and I assume I will need some kind of zener diode to make the low fuel light usable. I haven't found a thread that specifically addresses a solution to these issues, but I'm sure it's out there.
I would welcome any feedback.
Thanks
(http://i1320.photobucket.com/albums/u536/dmf996/IMG_0273.jpg)
(http://i1320.photobucket.com/albums/u536/dmf996/IMG_0234.jpg)
(http://i1320.photobucket.com/albums/u536/dmf996/IMG_0271.jpg)
Sorry, no feedback just completely entertained [popcorn]
Ha! My wife has the same sentiments. Poor man, tearing up a perfectly good machine. ;D
Another free subscription [drool]
Are those red/grey plastic things your air filters :o or just workshop caps?
I can't wait to watch this one! lovin that cockpit man
Someone, please help this man! This is so cool!
What brand of clip-on handlebars are those?
Quote from: DucRS on December 04, 2012, 08:45:57 AM
Sorry, no feedback just completely entertained (http://i.huffpost.com/gadgets/slideshows/266290/slide_266290_1813695_free.gif?1354114715776)
been wanting to use this one today, so Ill jus correct yours for ya...
Quote from: dufukincati on December 06, 2012, 04:56:14 PM
What brand of clip-on handlebars are those?
Looks like a set of ~2" rise Woodcraft clip ons with a Speedy Moto triple. Pretty stuff there, OP.
feedback - - stop asking IZ for photography advice
Yes, they are woodcraft. Gotten from Jeff , very helpful guy,for my 695. Kept when I sold it. Made some progress this week . Headlights installed, not finished. Tank striped, not cleared yet. Oil pressure on motogadget. Tech support very quick via email. They think a resistor parallel to my led will allow it to work with the stock sender, well see today. Starting to look like my bike now
(http://i1320.photobucket.com/albums/u536/dmf996/B0006153-FC38-43DA-B98D-6096C3978707-6621-000008FB98360246.jpg)