Any body have any problems installing a Oberon clutch slave with disengagement of the clutch stack. 07 s4r if it matters. It's a 29 mm bore
Thanks
I have an Oberon slave on My S4 and its superb also fitted one to my M750 , they are very high quality , and reduce clutch hand force by about 30% , have many pals who use them too.
suction bleeding at the slave using either amityvac or a syringe is foolproof method of ensuring no air in the system which is usually the cause of insufficient clutch lift ,
also thats the best way to bleed rear brake ....
Thanks ill give mine a shot.
I have one on my bike, works great. Hardest part was the bleed, but after a few tries, it's been flawless since.
Yours is getting stuck engaged? I remember there being a little push rod extender that you can put in the slave, did you use it? The pushrod, or whatever its called, on the S4R does not need it.
-Jim
Didn't install it yet I seem the little spacer