Ordered and received a new clutch rod from the dealer for my 06 Monster S4R. When I looked at it, it seemed odd, is this what it's supposed to look like? The one currently in my bike doesn't have that little horizontal pin. Hmmm.....
(http://i777.photobucket.com/albums/yy51/wbamiduro/Project%20Stealth/Sale%20Stuff/photo1_zps80a7be6e.jpg)
From reading here...
That's an 1100 EVO pin.
[bang]
Quote from: MonstaS2R on October 05, 2013, 05:37:03 PM
[bang]
Check the length compared to your old one.
If the length is the same...
drive out the pin. ;)
Yes, the part number that you ordered supersedes to that one, just as if it's a direct replacement.
[bang]
Which it isn't, well, at least until you drive the pin out.
Then it will fit.
Fully support the pushrod when you drive the pin out, it's a tight fit.
I'd like to hear what Henry Ford would say.