Print Page - Modifying M1100 rear axle? Qtn for machinists

Title: Modifying M1100 rear axle? Qtn for machinists
Post by: mickb on October 04, 2014, 04:46:55 AM

Hi,
Would you think its possible to 'cut' the wheel-mounting plate from a 1098 rear axle, and have this fitted to a M1100 axle (after removing existing plate)?
If so, is this a huge job, or is it possible to put a rough estimate in terms of hours required?

thanks

Title: Re: Modifying M1100 rear axle? Qtn for machinists
Post by: Dirty Duc on October 04, 2014, 10:40:14 AM

I think that would not be a soundly engineered solution.

The mounting plate is not the only difference between the two, so you still would not be able to mount the 1098 wheel on the M1100.

Title: Re: Modifying M1100 rear axle? Qtn for machinists
Post by: mickb on October 04, 2014, 11:42:14 PM

ok, thanks. I know the brake rotor is off-set, do you know of any other differences?

Title: Re: Modifying M1100 rear axle? Qtn for machinists
Post by: Dirty Duc on October 05, 2014, 08:29:08 AM

I believe the diameter of the axle is bigger on the 1098. This is the non-trivial part of what I think you are trying to do.

Ducati Monster Forum

Moto Board => Tech => Topic started by: mickb on October 04, 2014, 04:46:55 AM