Print Page - Bushing for rear sprocket

Title: Bushing for rear sprocket - 97 M900
Post by: greenohawk69 on July 14, 2018, 03:22:36 PM

Had one of the bushings within the bearing that the rear sprocket gets set into come out.

It appears that it was glued in from what I can see and feel was on it. It fell off within the OEM Brembo rear wheel.

Any suggestions on how to re-attach? My first thought is to use this KB Weld high strength epoxy to coat the oitside of the bushing and set it back in. (https://uploads.tapatalk-cdn.com/20180714/ddbf75badf5255dd4656bece630deeee.jpg)(https://uploads.tapatalk-cdn.com/20180714/b5afd63ebe1b213da560d3627b1dc36f.jpg)

Title: Re: Bushing for rear sprocket - 97 M900
Post by: Buhgaboo on July 14, 2018, 03:31:29 PM

It's time to replace them...kush drive...heat up the rim around the kush drive until water dances off it...then with a slide hammer pop them out...put the new ones in before it cools

Title: Re: Bushing for rear sprocket - 97 M900
Post by: greenohawk69 on July 14, 2018, 04:09:46 PM

Recommendation on replacement part? Vendor?

Title: Re: Bushing for rear sprocket - 97 M900
Post by: Buhgaboo on July 14, 2018, 04:13:49 PM

I don't have a source outside of the dealer...but I love buying parts from startwin.com...it makes more sense to buy more than one thing but the savings are significant

Title: Re: Bushing for rear sprocket - 97 M900
Post by: ducpainter on July 14, 2018, 04:23:39 PM

Check our sponsors.

Ducati Monster Forum

Moto Board => Tech => Topic started by: greenohawk69 on July 14, 2018, 03:22:36 PM