Title: generic turn indicator replacement? Post by: Privateer on April 20, 2020, 11:34:55 AM tried to get some generic indicators but the bolt/post thing was much bigger diameter than the OEMs so they wouldn't fit in the mounts.
anyone else experienced this, or did I just pay too little? thanks Title: Re: generic turn indicator replacement? Post by: koko64 on April 20, 2020, 12:15:49 PM I take it you mean the locating dowel thingo. If so, you were unlucky, I've never had that maybe just on the tight side. Can't trim them a little?
Title: Re: generic turn indicator replacement? Post by: greenohawk69 on April 20, 2020, 12:34:40 PM Yes. Just dremel them to fit.
Title: Re: generic turn indicator replacement? Post by: Privateer on April 27, 2020, 09:32:10 AM not the locating pin, the actual threaded rod.
Title: Re: generic turn indicator replacement? Post by: koko64 on April 27, 2020, 12:57:31 PM Ok, so it's not a replica part. Yeah, fat stemmed indicators require drilling out the hole, but then you can't go back to oem for whatever reason unless you can replace the bracket.
Title: Re: generic turn indicator replacement? Post by: koko64 on April 27, 2020, 01:38:03 PM Some eBay parts have the dimensions available or you can contact the vendor. You going for oem replica part or smaller aftermarket part?
|