I've been wanting to do this for a while.. I swap my coretech bag on and off from my St to my S2r. No problem for the ST, it has antlers. The S2R is another story. With the passenger pegs, it was not really an issue. That is until I went with the full arrow exhaust. Now anything that doesn't belong, should go. Not to mention that the pass pegs are two hunks of metal.
At first I thought about making a bracket. Sort of a grab handle. Then it struck me to see what sort of high end cabinet hardware was available. The spread between bolts is about 2.75 inches. Nothing with any meat that small. But while staring at all the different handles, it occurred to me that I did not need a handle. I needed a knob. And the one I settled on is either stainless or some alloy.
Of course the stock screw would snap off in a heart beat. But if you drill it out and tap it for the same thread as the screw that mounts the pass peg bracket, that should hold.
Well it turns out the knob is solid. It drilled clean (drill press). And the Kobalt tap and die set I got from Lowes a while back has the correct taps and dies for most all metric needs with small fasteners that get mucked up.
Below are some shots of what it looks like. The right side was easy. The left side you have to unbolt coil from the mount (2 allen screws). Then you can feed the screw in from the backside.
I placed threadlock on the threads to make sure it stayed put. You really can't put too much twist onto the knob since it's completely smooth. Since it is a stepped design, it's very Frankenstein.
This is before removal...
