I want a shorter termi on my S4RS, who can help me ?

[Saluti di Monstro]

Hello mostro's

Maybe you can help me or find someone to help me....

I am a Ducati fanatic from the Netherlands and also a member of the largest Ducati club in Europe (the DCN, Ducati Club Netherlands)

I have a S4RS (2008) and I want to buy a new exhaust: a Termignoni.

But I have a problem... My S4RS have a short tail and I want to have the Termi 96448606BC slipons, but these are too long...

When I want to have the lowest slipons 96025704B, the are only for the S4R before 2006 or the S2R800/1000...

The shorty Termi 96116707B is not my thing...

Please read my questions:

1. Is it possible to make the Termi 96448606BC slipons shorter, so they are nog longer than my shorter tail ?
2. Is it possible to fit (or make it fit) the lower termi 96025704B for my S4RS 2008 model ?

I hope that you can advise me, and sorry for my bad language...I tried my best...

Kindful regards from the Netherlands

Rob
 

[COWBOY]

Rob

Welcome to the site.

1.  It is possible to do this and I think there are a couple of threads here or on the old board where it was described.  Essentially it's carefully using a Dremel or other saw with the appropriate blade to cut through the carbon/metal and then riveting the cap back on.  I'd bet there is a shop in the Netherlands that will do this since I've seen some very nice and heavily modded bikes posted from your country.

2.  I'm not sure because I don't know the pipe diameters.

Cheers