S4RS Fault Code

[Desmofan]

Just done a belt and plug change on my 07 S4RS. All seems fine, bike fired and runs normally. Thing is that on first turn of the ignition switch the clocks sweep the dial as normal but the miles meter reads "NA Int" for a couple of seconds before returning to the normal mileage readout. Any ideas? Is it connected to the work I have done? Battery was off the bike during this. Cheers peeps.

[Speeddog]

That's the signal that you've crossed the mileage threshold for the standard service interval.

[Desmofan]

OK, thanks. That's good to know. It recently passed 6k so that would add up. I think at 6k it's a shim check. Right?