Modifying M1100 rear axle? Qtn for machinists

[mickb]

Hi,
Would you think its possible to 'cut' the wheel-mounting plate from a 1098 rear axle, and have this fitted to a M1100 axle (after removing existing plate)?
If so, is this a huge job, or is it possible to put a rough estimate in terms of hours required?

thanks

[Dirty Duc]

I think that would not be a soundly engineered solution. 

The mounting plate is not the only difference between the two, so you still would not be able to mount the 1098 wheel on the M1100.

[mickb]

ok, thanks. I know the brake rotor is off-set, do you know of any other differences?

[Dirty Duc]

I believe the diameter of the axle is bigger on the 1098.  This is the non-trivial part of what I think you are trying to do.