Matte Black Paint Issue ('07 M695)

[Red89]

Hi, everyone.

This is my first post looking for some help. I'm sure it won't be my last... I tried searching but couldn't find anything comparable to my issue.

I'm trying to figure out how to correct the paint on my matte black fuel tank. It's on my 2007 M695.

These resemble scratches but are not indentations in the paint, more like bulges. They sit proud of the finish and can easily be felt when running your hand over them. The tank is otherwise not distorted or damaged, so I am reasonably sure it's not from dropping the bike, etc. Truth be told, I have no idea what it could be.

I was thinking of sanding it flush, but then I'm concerned that too coarse a grit would leave visible scratches and too fine would create more shine than intended.

Picture for clarity, I hope the resolution makes the issue clearly visible. Help / ideas / experiences much appreciated.  

[ducpainter]

Anything you do, short of a complete refinish, will be just as visible as what you have.

That finish is not spot repair friendly.

[Red89]

Thank you for your reply! Bummer. I was worried that might be the case. Looks like I'll have to get it powder coated at some stage. Or stock up on paints and bravery.

[ducpainter]

Keep in mind, that tank is plastic. Powder coating would have to be accomplished using a low temp UV cure powder, if possible at all.

That color is an enigma. It isn't a straight flat black, the Euro brands used at the factory aren't readily available here in the states, so color match is difficult. Plan on refinishing all the parts that are that color.