Condor tire chaulk & Etrack

[herm]

I'm getting ready to install Etrack and a Condor tire chaulk in my 6x12 enclosed trailer. Has anyone else gone this route? Would love to hear your thoughts if you have, and bonus points for a picture or two.

[Zoomie]

Just finished a build of a 6x12 enclosed and am happy with the results! Etrack is for sure the way to go and wheel chocks are great for single person loading because the bike stands up on it's own while you go for straps. Pictures in the link below.

I bought the trailer and painted the walls pretty roughshod with white outdoor latex paint and did the floor with paint on bedliner before bolting down the e-trax. Did some rubber flashing around the seam just so that I could be sloppy with the bedliner and make sure it covered the floor to wall joint. Marking tape to mark the studs/beams and some LED battery lights. Really happy with it all!

[Zoomie]

Before

[herm]

Nice

Thanks for the pics.. I rolled on 2 coats of exterior gray primer in the interior of my trailer. Mostly finished with installing the Etrack, but got sidetracked by life, so not finished yet.

I'll post some pics when it's done.

[Zoomie]

Sounds great! The etrax is pretty impressive stuff and I think it now makes up more structure of the floor than the rails do. There was some frustration putting it in where the self tapping metal screws bent the rail down before getting traction on it to drive through, but 4/5 got good purchase and I backed up with a probably excessive number of wood screws into the floor panels. If I go back for more add ons it will probably be to put some on the side rails for accessory storage it isn't at full 3 bike capacity.