HEY 696 owners who upgraded to 1100 got a question for you

[causeofkaos]

i will soon be upgrading,closest dealer is 100+ miles away so cant just pop in and look.
question = are the clutch and brake levers different on the 1100 and will the 696 frame sliders work, i read the comp werks fender eliminator will not fit.
Thats pretty much all i can think of right now?? Anything else you can think of that might be good info
Thanks 

[DucNrun]

Different brake levers and master cylinders for sure.  Not sure about the rest.  FWIW, the M1100 has the same levers and reservoirs as my S4RS.

[causeofkaos]

good to know just trying to figure out what i will be buying...... again......

[gearhead]

 I dont see why the CW eliminator wont work.

[Raux]

apparently the special exhuast valve on the 1100 is in the way of the CW tail.

[booger]

DP sells a fender eliminator kit that works with the 1100 or so I've read

[sfarchie]

Yes, the 696 frame sliders will fit the 1100 frame since they're the same. I had RhinoMoto barends which accomodated my CRG LS mirrors, however the diameter of the 1100 bars are slightly smaller. I believe amcloud just took off the tube which the expansion bolt presses against and it fit. I haven't gotten around to try it since I'm out of commission due to ACL reconstructive surgery.

I don't believe the levers are the same, but I wasn't planning on changing them so I really don't know. One big diff between the 696 and 1100 is the clutch release. I changed out my 696 to CRG adjustable levers since it was such a far stretch to get into the friction zone. With the 1100, it grabs almost immediately so I didn't feel the need to replace my levers. I ordered termis instead.  

Oh, if you get the full termis, you can use the CW tail. And yes, I ordered the full termis!