Need a new beer tray

[rbarrero]

Hi - I've accidentally damaged the beer tray on my '07 M695. I was getting off the bike and my heel hit the right tail light hard enough to break the soft plastic part that holds the tail light up. The beer tray itself is OK, and so is the tail light... but since that plastic piece holding it upright is broken, the tail light hangs down and sits on my high-mount pipes.

I'm looking for a beer tray replacement (I actually like the tail and beer tray - no fender though) or a replacement for that plastic bit that holds it all together. Other tips would be appreciated as well.

Thanks!

Rafael

[NAKID]

PM me with your address...

[somegirl]

You could do what someone I know did... (eventually got replaced).

[bmonty72]

If you get a new one...may i have your old one?  I am looking into chopping up a beer tray similar to what "stopintime" did.  On his he shortened the whole tray and trimmed off the "ears" that the signals mount to.  Please PM me and let me know...Thanks!!!!

[rbarrero]

I tried to do that for a while... i made a quick, thin, wood splint and covered it with some black electric tape. Eventually due to riding it would loosen and hang down again... looking worse. But c'mon, it's a Ducati... gotta look good!

Rafael

You could do what someone I know did... (eventually got replaced).

[rbarrero]

Absolutely. Sounds like a cool idea... especially if you have an integrated tail/brake light. I will let you know as soon as its available.

Thanks,

Rafael

If you get a new one...may i have your old one?  I am looking into chopping up a beer tray similar to what "stopintime" did.  On his he shortened the whole tray and trimmed off the "ears" that the signals mount to.  Please PM me and let me know...Thanks!!!!

[amcloud]

How about 1 or 3 minute epoxy?? My right turn signal has been epoxied on for a while now.  The epoxy is clear and hardly noticeable.