I posted this on the other monster forum and thought i would post it over here as well.
First let me apologize for not having pictures showing the removal of the charcoal canister. I don’t have pictures because I was having issues with the gas tank pulling a vacuum every time I ran the bike so I started taking things apart to figure out where the gas tank vent lines were fouled and causing the vacuum in the gas tank.
Step 1: remove the left side air deflector that holds the charcoal canister.
Step 2: remove the three bolts that hold on the right side air deflector.
Step 3: remove the vapor hose that attaches to the throttle body on the right side that is behind the air deflector.
Step 4: remove the barb fitting that is installed in the throttle body and replace with a screw and the copper washer that was on the barb fitting to seal the hole. I don’t know what size screw to use because I used the leftover screws from the tail chop that I did.
Step 5: remove the vapor hose and barb fitting from the left side and replace with a new bold and the copper washer that came off of the barb fitting.
Step 6: at this point I cut the fuel tank vent hose at the charcoal canister to keep it as long as possible or you can cut it at the top of the tank and use a T fitting and connect the big hose to the smaller hose at the top of the tank and use the smaller hose run to vent the tank to under the bike where it is already ran.
Step 7: install the left side and right side radiator shroud/side panels on the bike and you are done.