Will's Thread

[WillS]

Will,

Would either of these pumps work on my monster?

http://cgi.ebay.com/ebaymotors/DUCATI-08-MONSTER-S2R-1000-OEM-GAS-FUEL-PUMP-PUMPS_W0QQitemZ190357647144QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item2c52332f28

or

http://cgi.ebay.com/ebaymotors/05-06-Ducati-Multistrada-1000-DS-S-Fuel-Pump-MINT_W0QQitemZ250509851441QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item3a538cfb31

or

http://cgi.ebay.com/ebaymotors/Ducati-Multistrada-620-fuel-pump-gas-pump-2006_W0QQitemZ260527020396QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item3ca89ed96c

I figure this might be faster than waiting until you guys hear from Ducati.

Let me know.

Thanks!

s2r assemblies and 620' s will work, hope you get a good one.
let us know
happy holidays
-will

[Xerxes1769]

Will,

I ended up buying the S2R1000 fuel pump...(since it was the newest and less mileage one)

http://cgi.ebay.com/ebaymotors/DUCATI-08-MONSTER-S2R-1000-OEM-GAS-FUEL-PUMP-PUMPS_W0QQitemZ190357647144QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item2c52332f28

should be here hopefully by the end of this week, I put the fuel pump/flange I had ordered from you guys on hold just in case this pump doesn't work.  As it turns out the Ducati factory is on a month long vacation and my pump was going to take a lot longer than I was previously told.  So hopefully this will work and I can get the bike out sometime soon.  

Also bought some new brake/clutch reservoirs and was hoping you guys could install them...they should be here end of this week...

for clutch and brake


and for rear brake

[DRKWNG]

Your bike has the coffin masters right?

[Xerxes1769]

Yes Sir!  Coffin style and fugly as all hell!  Don't tell me they will not fit!?!

[DRKWNG]

Well, those are a one piece design.  The reservoir is permanently attached to the master cylinder if I am not mistaken...

[Xerxes1769]

Dang!  Now to see if I can switch the three reservoirs for something else...

[WillS]

yes, the pump...good
the brake and clutch stuff, nope, no worky,

let us know when you get the pump

[Xerxes1769]

Will,

Dropped off the pump and got a look at the bike...the clip-ons look fantastic!  Hopefully pump will fit and work and I can get the bike back soon.

[Xerxes1769]

Will,

Bike's running great so thanks!

[WillS]

no, no need to thank, thank you

[DRKWNG]

yes, yes need to thank.  you thanked.

[WillS]

har har

[DRKWNG]

 

[RUFKM]

Aloha Will,

Bringing the S4RS in for safety check Friday and change the front rotors/pads to stop the jurging.  Dropped off new BrakeTech rotors with Shawn when I made the appointment.  The rub is there's a little caution note on the installation sheet that says the stock bolt shoulders may not fit the rotor hubs.  I want to go new bolts anyhoo so I'm hoping you could maybe check the fit before Friday so if there's a problem maybe it can be addressed before the appointment.

Mark

[WillS]

ok, i'll take a look tomorrow

see ya on fri