![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail001.jpg)
Here's the kit. I was very impressed with the quality and fit of this Product. A+
![applause](https://ducatimonsterforum.org/Smileys/classic/applause.gif)
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail028.jpg)
Tools I used
4mm hex bit socket
5mm hex bit socket
4mm allen wrench
5mm allen wrench
ratchet with 3" extension
small flat screwdriver
T20 security bit
di-electric grease
electrical pliers
#1 Remove seat#2 Remove three screws above plate mountI used a 4 mm hex bit
#3 Remove four cap bolts from fender assemblyYou need a holdback to do this. I used a 5mm hex bit on top and a 5mm allen wrench on bottom. pic below
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail006.jpg)
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail009.jpg)
lower the unit and disconnect seat lock cable and blinker wiring plugs. ( I labled both sides of the right blinker plug for easy reinstalation)
next disconnect the exhaust valve cable. A plastic clip secures it in place. pic below
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail015.jpg)
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail011.jpg)
Now you can remove the brakelight plug. I had some trouble removing the pug so I removed the brakelight itself to give me more room to get it.( I used a T20 security bit) pic below
#5 Remove assembly from bike reconnect exhaust cable and clip#6 remove blinkers and seat lock and install on tail tidyI did one blinker at a time so i didn't confuse left or right.(fit was perfect) Connect brake light and spade connectors to led wires (spade connectors included in kit)
#7 reconnect electrical and test![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail019.jpg)
If all is well secure wiring with included zip ties
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail020.jpg)
connect seat lock cable.
#8 loosely install unit with included spacersI used some di-electric greace on the top of the spacers to hold them in place during install ( tip included in instructions)
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail021.jpg)
Check to make sure no wiring or cables are being pinched then tighten tail tidy.
Check seat lock operation.
Enjoy
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail025.jpg)
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail026.jpg)
random pics
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail018.jpg)
![](http://i885.photobucket.com/albums/ac51/rllout/Tidytail/tidytail017.jpg)
This kit fit perfectly very high quality I would recommend this product