ReXXer user unit Seimens ECU flash

[DucNaked]

Although this doesn't really need a "how to" I thought I'd put up a little something.

First thing order your Rexxer.  Make sure you give all the specs you want the map to have. Such as removing the 02 sensors, removing the flapper valve, full system or slipons, high flow filter, and so on ...............  At this time you can specify a custom start up greeting. This can be up to 15 characters in capitols. Only common letters and numbers. Also at this time you should request the stock map, as the Rexxer can't store the original for the Siemens ECU.

With that done you should receive this
Install the provided software.
Plug the Rexxer in with provided usb cable. You now have to find the driver. Which is in the c drive in a file called Daniele-Moto After that you should be able to launch the user program and change the devices language. To do this hit the link botton. After the link use the Device tab and use the Select the Language.

Now just plug the Rexxer into your bike and follow the prompts.
You will get a screen that says it cant back up the current map. If you have the stock map file don't worry about it and hit the checkmark to proceed. You should see this Then this When I was at this point I didn't shut off my key. I hit the up botton and went into the Rexxers other features
Shut the key off, remove the Rexxer, and go for a ride.  [moto]

[ungeheuer]

Nice write up DN. Good job.

[Veloce-Fino]

Thanks! 

[causeofkaos]

so what is your custom greeting??  

[DucNaked]

so what is your custom greeting?? 

DUCNAKED M1100S

[mattc7]

does christian at rexxer have a direct email?

[DucNaked]

does christian at rexxer have a direct email?

cs@daniele-moto.de

[ajw85]

where do you plug the rexer into your bike?

[Veloce-Fino]

where do you plug the rexer into your bike?

Through the exhaust pipe.




Kidding, Through the plug under the seat of the bike in front or the tool kit.

[mickb]

With the device plugged into USB, when I launch the s/w & click 'Link', I get a message 'device not found', any clues?

[DucNaked]

With the device plugged into USB, when I launch the s/w & click 'Link', I get a message 'device not found', any clues?

Did you load the device drivers? I always launch the program then plug the device into the usb ports.

[diurdac]

DucNacked. Can you send me a copy of the standard map of the ECU?

[diurdac]

Ducknaked Worte:
......................At this time you can specify a custom start up greeting. This can be up to 15 characters in capitols. Only common letters and numbers. Also at this time you should request the stock map, as the Rexxer can't store the original for the Siemens ECU.

And I ask you: How many characters in total? How long is the sended RexXer file?

Please: Can send me "your" stock map by email? Thanks in advance.