Oberon Clutch Slave Cylinder

[duk too]

Quick delivery from Motowheels.
Install went okay. A bit of a messy job. Trying to catch fluid and keep it in container, blah, blah blah. Had to bleed the system at least 10 times to get a good clutch.

The Oberon piece is exquisite looking , but clutch pull is not reduced as much as I dreamed/wanted it to be.

They say around 30% less pull, I think maybe 15 to 20% less pull. Its hard to gauge, but it is a little better and anything is better than stock. IMO

[sfarchie]

That sounds about right. A friend also has the Oberon, but I went with the NCR slave cylinder. When we compared the pull, the NCR was significantly smoother and easier, but you also pay nearly twice as much.

http://www.desmoworks.com/index.php?main_page=product_info&cPath=401_418&products_id=501