I’m modifying a s4rs a little more along my taste, which involves a lot more taking off than putting on. As you can see I’m still in the ugly mockup stage, but it does crank and run. Basically, I’m using a 996 tank, moving the battery/ecu/relays under the seat,And adding 2 stacked projector lights and a motogadget tach up front.
There are 2 wires from the ecu I can’t id, blue/yellow body connector pin 13 and orange/blue body connector 7. Both went to the dash, but I at a loss as to their purpose. My led for low fuel stays on all the time and I can’t get the stock oil pressure sender to register. I have a motogadget oil pressure sender coming, and I assume I will need some kind of zener diode to make the low fuel light usable. I haven’t found a thread that specifically addresses a solution to these issues, but I’m sure it’s out there.
I would welcome any feedback.
Thanks
