..............not including shipping but still a damn good deal [bacon]
(https://www.oncycles.com/products/cyclecat/images/MCS00107a.jpg)
Linky here  [coffee]
https://www.oncycles.com/browse.asp?department=standsjackslifts&category=frontstands&brand=cyclecat (https://www.oncycles.com/browse.asp?department=standsjackslifts&category=frontstands&brand=cyclecat)
			
			
			
				as long as they don't charge $155 for shipping, i'd say go for it.
 ;D
			
			
			
				Quote from: derby on May 26, 2009, 04:14:56 PM
as long as they don't charge $155 for shipping, i'd say go for it.
 ;D
Whew! For a minute there I thought you were going to post a "derby."  [laugh]
And no. Shipping was about $25. Still a hell of a deal.  [thumbsup]
			
 
			
			
				Where does that one hold the bike?  The bottoms of the forks?
			
			
			
				I ordered two of these last week, they are awesome
Adam
			
			
			
				That looks like a nice stand and an even better price.  What I'd like to find is one of their rear stands ( the one where you can lift the bike from the sidestand).
			
			
			
				Quote from: mojo on May 26, 2009, 07:28:16 PM
That looks like a nice stand and an even better price.  What I'd like to find is one of their rear stands ( the one where you can lift the bike from the sidestand).
Good luck ... They're out of stock everywhere and I"ve only seen one show up on eBay ($160)  :(
Adam
			
 
			
			
				Thanks for the heads-up.  That's a screamin' deal!
I ordered one - it'll match perfectly with my silver Cycle Cat UCS1 rear stand...   8)
			
			
			
				Can the front wheel be removed with this stand?
			
			
			
				Quote from: pennyrobber on May 26, 2009, 10:35:49 PM
Can the front wheel be removed with this stand?
You can remove the wheel, but not the forks.
			
 
			
			
				Just ordered. $44.31 including shipping to CT...
			
			
			
				Hot nuts!  Snagged mine.  
RE reat stands... best of luck.  They have been out of production for a while - so you're going to be looking over the 2nd hand market.
			
			
			
				bought'd.
wish they still had red ones to match my fg rearstand, but at this price I can just rattlecan it.  sweet deal!
			
			
			
				Holy tits! I'd be an ass not to buy one, at that price!
			
			
			
				I need some help, here, and this might be a thread jack, but this is a sweet deal.  2 things..
1.    I believe I have to get front fork sliders/pegs in order to use the front stand...
2.    I would like to buy something else too, but not sure of fitment
https://www.oncycles.com/browse.asp?page=3&department=clearance&category=billetaccessories (https://www.oncycles.com/browse.asp?page=3&department=clearance&category=billetaccessories)
which one will fit a S4RS...
thanks for the help..
i would like to score a triple clamp if possible
			
			
			
				wish i didn't already have a front stand  [roll]
however - i could use a new rear-stand that uses spools (as opposed to the 'L' shaped under-swingarm holders)
			
			
			
				Quote from: AfroS4RS on May 27, 2009, 08:12:56 AM
I need some help, here, and this might be a thread jack, but this is a sweet deal.  2 things..
1.    I believe I have to get front fork sliders/pegs in order to use the front stand...
2.    I would like to buy something else too, but not sure of fitment
https://www.oncycles.com/browse.asp?page=3&department=clearance&category=billetaccessories (https://www.oncycles.com/browse.asp?page=3&department=clearance&category=billetaccessories)
which one will fit a S4RS...
thanks for the help..
i would like to score a triple clamp if possible
1. No, you don't need the fork sliders to use this front stand. The rubber mounts of the front stand cradle the bottom of the forks thereby lifting the front wheel off the ground.
2. I don't think the top triples are available for your bike. 
			
 
			
			
				I was holding out to get a PitBull front stand with the bottom triple pin but couldn't pass this up. Thanks for the heads up. 
			
			
			
				Thanks Pedro,
yeah, they didn't have the DTC-7 for my bike.  I did get the front stand and the billet 3 piece clutch cover $50 bucks..not too bad.. I'm a sucker for deals, and not just buying one thing...  [bang]
oh well, Just in case I want to change it up..
			
			
			
				Nice deal for sure! You shouldn't need anything else to use the stand. The set up looks very similar to my Pit Bull front stand. And for those who have never used a front stand like this YOU HAVE TO HAVE THE BIKE SUPPORTED BY A REAR STAND FIRST!!!! Rear stand first THEN the front stand!!
			
			
			
				Quote from: pennyrobber on May 27, 2009, 11:39:18 AM
I was holding out to get a PitBull front stand with the bottom triple pin but couldn't pass this up. Thanks for the heads up. 
I have a PitBull front stand with a pin, but I ordered the Cycle Cat stand anyway.  If you're just removing the front wheel, the Cycle Cat stand will make the job a tad easier, as the legs of the PitBull stand are a little in the way of the axle.
			
 
			
			
				Quote from: pompetta on May 27, 2009, 02:16:32 PM
I have a PitBull front stand with a pin, but I ordered the Cycle Cat stand anyway.  If you're just removing the front wheel, the Cycle Cat stand will make the job a tad easier, as the legs of the PitBull stand are a little in the way of the axle.
Plus the handle removes for storage or whatever  ;D
Adam
			
 
			
			
				Just ordered 2.    Our shipping charges were a bit more than NAKID's but still a good deal. [thumbsup]
			
			
			
				Quote from: somegirl on May 27, 2009, 08:18:37 PM
Just ordered 2.    Our shipping charges were a bit more than NAKID's but still a good deal. [thumbsup]
I better get a second bike to put on the other one then.  ;D
			
 
			
			
				I caved and bought one  :)
			
			
			
				I got a notification that it will be delivered TOMORROW! Holy crap, I only paid for the UPS Ground. There may be an issue though, it was shipped signature required. The wife is out of town so I may not be there when they deliver...
			
			
			
				I didn't need them, but I think it is an upgrade from what I've been using, so.....I just now called them up and ordered three of them. They are out of the red ones, but they still have silver in stock.....I kept teetering between buying 3 or 4 and settled on the lesser. I figure I can sell my old two stands and make up some of the cost of these three, plus, if I decide to sell one of these new ones, I have a few friends who could use them......Hmmmm...Maybe I should order a fourth. LOL
			
			
			
				annnnd I just ordered a third one, hey what the hell  [laugh]
Adam
			
			
			
				For those that wanted the red one, you can always have it powder coated.  8)
Of course that would cost more $$, but if you really wanted to.....what the hell.  [coffee]
			
			
			
				Quote from: Pedro-bot on May 28, 2009, 09:11:18 AM
For those that wanted the red one, you can always have it powder coated.  8)
Of course that would cost more $$, but if you really wanted to.....what the hell.  [coffee]
Or, wrap it in red nylon or gaffers tape  [laugh]
Adam
			
 
			
			
				i will not be assimilated.....
			
			
			
				I bought one, shipping was a beast at $44 something to the Portland Oregon area. OUCH! That was for UPS ground too! Oh well, when they are usually about $200 after shipping I guess $64 total isn't bad at all (and the wife didn't get mad at all when I told her how good of a deal it was). 
The Doc
			
			
			
				$28 shipping to south LA, but still a great deal. Thanks!
			
			
			
				Awesome deal.  $140 for 3, split shipping with a couple of guys at work.  Thanks for the heads-up!
			
			
			
				Mine shipped today. $44.16 out the door to NYC.
			
			
			
				Quote from: Chchadder on May 28, 2009, 11:16:02 PM
Mine shipped today. $44.16 out the door to NYC.
That's exactly what mine was to South East CT...
			
 
			
			
				Yeah, mine was the same (~$40) to my LA (los angeles, not the swamp).  Still $60 beats $150 anyday.
			
			
			
				$50 to Kansas.
			
			
			
				Just received mine.  It is much heavier than I expected, but well built.  The stand was very easy to use and works great.  Add in the crazy price and I am one happy customer.   [thumbsup] [thumbsup] [thumbsup]
			
			
			
				Quote from: XJDAVE on May 29, 2009, 02:11:28 PM
Just received mine.  It is much heavier than I expected, but well built.  The stand was very easy to use and works great.  Add in the crazy price and I am one happy customer.   [thumbsup] [thumbsup] [thumbsup]
Got mine today, too.   It works perfectly on the Monster.  [thumbsup]
I hear ya about the weight of the front stands, but the rear stands are even heavier.  [laugh]  It also looks like the silver finish on the front stand is a bit darker than the CC rear stand I bought a few years ago.  Doesn't matter, though, at this price.  
			
 
			
			
				Appear to be all gone> Note to self: remember to check the forum even on business trips
			
			
			
				Quote from: bluemoco on May 29, 2009, 02:20:05 PM
 It also looks like the silver finish on the front stand is a bit darker than the CC rear stand I bought a few years ago.  
If that is bad, I have a pitbull rear and a CC front.  Now the fashion police are going to come after me.   [leo] That may be a felony in some sates. 
			
 
			
			
				Got mine today as well. Well packaged but because it's one big piece (except for the handle) the box was HUGE!.
			
			
			
				Quote from: NAKID on May 29, 2009, 05:41:15 PM
Got mine today as well. Well packaged but because it's one big piece (except for the handle) the box was HUGE!.
That's what she said.
			
 
			
			
				Quote from: bluemoco on May 29, 2009, 02:20:05 PM
 It also looks like the silver finish on the front stand is a bit darker than the CC rear stand I bought a few years ago.  Doesn't matter, though, at this price.  
leave the front one out in the sun for a few days - it'll probably start to even out
			
 
			
			
			
			
				Quote from: yuu on May 29, 2009, 08:28:42 PM
leave the front one out in the sun for a few days - it'll probably start to even out
I bet you're right.  
Seriously,  though, I can't complain.   For $20 plus shipping, this front stand is a screamin' deal. 
			
 
			
			
				Got mine today  [thumbsup]  Works great!
			
			
			
				got mine, now i just need to get a rear stand so i can use it. ;)