Doing my first belt change. The vid says th set the tension the following way. You want a 5mm hex to be able to slide by the tensioner wheel and a 6mm not to.
Is that acceptable?
I don't believe that spec works for a 1000 motor
Quote from: ducpainter on October 03, 2014, 01:55:40 PM
I don't believe that spec works for a 1000 motor
Why would it be different for a 1000 motor? I thought all the 2 valve motors were the same.
Different length between pulleys.
OK figured out what to do on this model. Anyone have recommended software? Going to pick up a mic tomorrow.
PM me your email address and I'll send you a copy of DucatiDiag belt tension software. Best tension software I've used.
PM sent. Greatly appreciated.
Tell the belt to take ten deep breaths. It will help it to relax a bit. [thumbsup]