Oil Bypass Spring

Started by TitanMonsterS4R, September 05, 2012, 12:39:43 PM

Previous topic - Next topic

TitanMonsterS4R

Quote from: ducpainter on September 06, 2012, 06:02:46 AM
was the cooler hot?

It did get hot but I suspect it wasn't as hot as the engine temp which was reading 210 F.  I was able to touch the cooler which was very warm with my bare hand for a couple of seconds before it got too hot
06 Monster S4R - Red/Black Final Edition

clubhousemotorsports

You have it right in that the diverter is there to send the oil through the cooler. The pump sends it out the top casting boss and into the cooler. This is also connected to the hole covered by the diverter, the oil will take the easiest path so without something to cover the hole the oil just goes through the filter.

I doubt it would harm anything running with out the valve as it should be the same for those bikes with no coolers, as long as the cooler gets some oil it will send what gets in there back to the cases. The valve is used as a blow off valve in case of a blockage in the cooler as already stated. No temperature related functions, though there used to be a aftermarket setup that bypassed the cooler at low temps.

The heads get fed oil through the center of the filter not the sides, the oil is delivered to the filter either through the small hole (non-cooler bikes) or if there is a cooler (and diverter)  then the oil goes first through the cooler then return back through the lower line dumping it into the filter.

ducpainter

There you have it...

Thanks.
"Once you accept that a child on the autistic spectrum experiences the world in
 a completely different way than you, you will be open to understand how that
 perspective
    is even more amazing than yours."
    To realize the value of nine  months:
    Ask a mother who gave birth to a stillborn.
"Don't piss off old people The older we get, the less 'Life in Prison' is a deterrent."



TitanMonsterS4R

Thanks everyone.  The knowledge of this board never ceases to amaze me  [clap]
06 Monster S4R - Red/Black Final Edition

Speeddog

A picture to go along with the words.

Port in the oil filter well, at the bottom of the pic, with red wire coming out.
That's the one the bypass spring covers.

Port at the top with the 2 red wires coming out, that's where the oil pump output connects.

Port at the right, red wire, is the output to the cooler.


- - - - - Valley Desmo Service - - - - -
Reseda, CA

(951) 640-8908


~~~ "We've rearranged the deck chairs, refilled the champagne glasses, and the band sounds great. This is fine." - Alberto Puig ~~~

ducpainter

Quote from: Speeddog on September 07, 2012, 06:43:18 PM
A picture to go along with the words.

Port in the oil filter well, at the bottom of the pic, with red wire coming out.
That's the one the bypass spring covers.

Port at the top with the 2 red wires coming out, that's where the oil pump output connects.

Port at the right, red wire, is the output to the cooler.



coolio  ;D
"Once you accept that a child on the autistic spectrum experiences the world in
 a completely different way than you, you will be open to understand how that
 perspective
    is even more amazing than yours."
    To realize the value of nine  months:
    Ask a mother who gave birth to a stillborn.
"Don't piss off old people The older we get, the less 'Life in Prison' is a deterrent."



TitanMonsterS4R

06 Monster S4R - Red/Black Final Edition