S2R 1000 Oil leak from vertical cylinder head bolt

[short circuit]

You would need 8 to do both heads.

I'd go with Brad's gasket fix, less of a PITA to install.

Do I have to pull out the rocker shaft to install these small o-rings? what is Brad's gasket fix???

[Speeddog]

Only pull the shafts out far enough to swap the o-rings, IIRC maybe 4mm or so.

DO NOT pull them out further, you'll risk dropping rockershaft shims on the inside.

Brad's gasket fix is to use the old-style paper cam cover gaskets.
Better way to go, IMO.

[short circuit]

Got it. Do you happen to have a part # for those? Let me know

[brad black]

the earlier model gasket is 066092310.  you need to put a couple of holes in it.  when i was in san diego last year i gave one i had modified to chris at california cycleworks to see if he wanted to replicate, but i'm not sure how he went with it.

[short circuit]

the earlier model gasket is 066092310.  you need to put a couple of holes in it.  when i was in san diego last year i gave one i had modified to chris at california cycleworks to see if he wanted to replicate, but i'm not sure how he went with it.

I see. Thanks, I will buy couple of those just in case if it leaks again. I used silicone to seal it and buttoned it up i hope it doesn't leak again, lol. Thanks fellas

[Raux]

Iirc a service bulletin said seal the whole cover area with sealant,

[krista]

the earlier model gasket is 066092310.  you need to put a couple of holes in it.  when i was in san diego last year i gave one i had modified to chris at california cycleworks to see if he wanted to replicate, but i'm not sure how he went with it.

Finishing up the MTS1000 tank mold before anything else.