Custom Rearsets Opinions, Thoughts, Criticism's please

[DucLeone]

Like This

exactly but i'm lookingfor the three hole ones

[fasterblkduc]

Like This

I forgot about those. Do you have any more? I need two adapters.

[fasterblkduc]

yes, exactly, and we all want a set so see if you can get a bulk discount on the 19.50 

No one is looking for a discount. We are looking for replacement pegs that aren't made anymore.

[djrashonal]

No one is looking for a discount. We are looking for replacement pegs that aren't made anymore.

Note the smiley, it was a joke, i am very familiar with the fact they are not made anymore because i just sold my set, thanks though.

[fasterblkduc]

Note the smiley, it was a joke, i am very familiar with the fact they are not made anymore because i just sold my set, thanks though.

[TAftonomos]

Jumping in on this, because....it's something else I want to do.

I had a pair of CC on the bike, then was offered quite a bit of money for them....so they are gone.

I tried pressing the rubber bushing out of the stockers....and ruined it.  I COULD just turn up a insert to replace the burrer bit (cause you can't buy it seperate), but I'd still be sporting stock rearsets)

I can machine the round parts fine on my lathe....but a mill isn't in the works until I get out from under some revolving debt....

[Some Dude]

I'm going to try these shock bushings from Summit Racing
Click Here

I looked for weeks for something like the stock bushings and I found 1 place that could get them but they were $15ea. And a minimum order of 400.  They also found something similar for me but it would have been $25 Ea.

If the shock bushings don't work I'm going to look at These

[TAftonomos]

I can turn some delrin, bore a hole and press in a sleeve.  Would appear to be factory.  Of course, if I can buy the OEM ones for $10, I'll just do that

Thanks for the link.....what ideas do you have for modding the stockers?  PM me!

[Javamoose]

....but a mill isn't in the works until I get out from under some revolving debt....

What do ya need milled?

[Some Dude]

I have an old CC peg From a set I bought to repair and sell.  I can get most of the measurements I need from that.  Could somebody put up a good picture showing both ends, and give me a measurement from end to end.  The peg I have has the outside end ground off.

[TAftonomos]

I'll take pics of mine tomorrow...right before I box them up and ship them off to the new owner 

I have some good ideas about what a new set would look like, but I can't draw/CAD worth a darn.  Would take me twice as long to draw them as it would for me to knaw them out of billet with my teeth!

[DucLeone]

BUMP!!

any decision on the 3 hole adjuster arms for the Cycle cat s*R rearsets?

really would like to replace mine!!