796 riser ==> fit the 1100???

[M1100]

Hey I am wondering if the 20mm rise on the 796 is the riser or the riser + the bars (if they are different)

So.... if it is just the riser, can I switch mine out on my 1100 for this and get a 20mm rise?

That would be just about right!

[Raux]

not certain, but isn't the 1100 bar a variable section bar?

if so isn't it a large diameter at the clamp?

and i think i read the 796 bar changed the sweep

[M1100]

Yeah, I wasn't sure about sweep or rise in the bar itself.... just wondering if the bottom clamp would fit and supply the 20mm.

[junior varsity]

The 796 bar riser fits the 1100.  We've done this for a customer recently.

The 796 and 1100 use the larger diameter tapered bar. The 696 is the exception with the non tapered bar.

[M1100]

So I wasn't the first to think of it!!  Dang.... glad it works, tho.  a m, did it give the 20mm of rise?  What is the cost on that part, and did it require any re-routing or anything?  THANKS   

[junior varsity]

Yes, the rise was the same as the 796 - no need to reroute anything. Get a double bonus and adjust the bar sweep to your liking when you are wrenching about, and make sure your brake/clutch controls are in positions that are comfortable to you. (no awkward bent wrists!)

36011271A - Cavallotto Inf. (Finito) +20 D. 28,5 M796

$75.00

(I work at AMS if you are feelin' like ordering it).

[M1100]

Thanks... I am unclear on how to adjust the bar sweep? 

[junior varsity]

Rotating the bars within the riser. Then adjust brake and clutch controls so they are at the correct angle, keeping you from having an awkwardly bent wrist.

[M1100]

Thanks!!  I am definitely going to do this mod....