60mm Risers on a 2011 M696?

[NateNewThread]

For my next project I was thinking about bars and risers from rizoma. I measured the stock risers from the base to the center of the bar and they were about 57mm. My question, does anyone have 60mm risers on their M696? Can you use the stock cables or does the 3 mm not make any difference? Any input would be appreciated.

[TWDucfan]

Will follow this thread closely. 

[ceytor]

i tried it on my 2010 696 and both the throttle cable and clutch was a bit short

[Link]

I have the 60mm risers & bars on a 696, clutch was no problem, throttle cables were a bit short but they worked after I took all the adjustment out of the cables. It wasn't ideal so I had new cable made 1" longer from MotionPro it only cost about $30.00 & it's a nice cable. It only took about a week for them to make it & ship it.