relays

Started by jefflund18, June 02, 2013, 05:52:49 PM

Previous topic - Next topic

jefflund18

Hi I have a 2006 ducati monster s2r 800...I was installing new tail/ signal lights and my lp prongs had touch when I put the seat on and shorted out bike...I traced wires to relay beside battery and no ground nor positive to one side of the relay and no power to bike other than brake light when brakes are depressed with key on and fuel pump cycle for acc no guage no headlights driving lights or signalsl.. jw if anyone knows what is all in the relay on left side of battery and tested all fuses are still good what to look for next as well??

suzyj

Quote from: jefflund18 on June 02, 2013, 05:52:49 PM
Hi I have a 2006 ducati monster s2r 800...

I was installing new tail/ signal lights and my lp prongs had touch when I put the seat on and shorted out bike...

I traced wires to relay beside battery and no ground nor positive to one side of the relay

and no power to bike other than brake light when brakes are depressed

with key on and fuel pump cycle for acc no guage no headlights driving lights or signalsl.

. jw if anyone knows what is all in the relay on left side of battery and tested all fuses are still good what to look for next as well??

I broke it up a bit in an attempt to decipher it, but still lost the plot at the "with key on" bit.

Anyway, I'm sure you've blown fuses. You should double check.

There are two relays on the left side. One turns the fuel pump on, and the other enables the headlights.


2007 Monster 695 with a few mods.
2013 Piaggio Typhoon 50 2 stroke speed demon.

jefflund18

Ive double checked all fuses and bike wont start gages dont even light up or come on...
I was already done installing the lights and the socket for lp light (which i no longer needed with the new lighs) pinched between seat when I went to put it back on

suzyj

There's a 30A main fuse on the left side near the relays. Sounds like that's blown.


2007 Monster 695 with a few mods.
2013 Piaggio Typhoon 50 2 stroke speed demon.

Howie

Check all fuses with a meter, not just visual.  Don't forget the main fuse.

Yep, hard to decipher.  Do the gauges sweep?  Does the fuel pump cycle when you turn the key on?  Does the bike start?  What warning lights come on?  What are lp prongs?

OK, caught between posts.  Check the main fuse, then get back to us.

jefflund18

I know of the 40a on like bottom side of battwry then two block fuses to the realys then fuse box on opposite side....im not sure where the 30 a is tho

Thank you for your time and consideration

jefflund18

The lp prongs inside the license plate light socket positive to negative collided and no gage sweep doesnt start fuel pumo cycles thats all I get

Howie

40 amp is correct, same fuse. 

Quote from: jefflund18 on June 02, 2013, 07:07:44 PM
The lp prongs inside the license plate light socket positive to negative collided and no gage sweep doesnt start fuel pumo cycles thats all I get


Ah, should have figured that one out

jefflund18

Yea that fuse is good

jefflund18

Do you think there is any possibility of burning out a couple wires??

suzyj

Quote from: jefflund18 on June 02, 2013, 07:40:48 PM
Do you think there is any possibility of burning out a couple wires??

There is, but it's very remote.

What are you doing to check the fuses?


2007 Monster 695 with a few mods.
2013 Piaggio Typhoon 50 2 stroke speed demon.

jefflund18

They are all the sight fuses then test light I haven't dont much hands on time to the bike for troubleshooting but before I tear to much  apart I wanna have a good idea what to look for

jefflund18

Is there any possibility I fried my ecu?

brad black

yep, it's make the beast with two backsed.

i'll give you $10 for it.
Brad The Bike Boy

http://www.bikeboy.org

jefflund18