Main Menu

Valve clearances for 09 696

Started by fragile_this_side_up, July 02, 2015, 05:53:58 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

fragile_this_side_up

July 02, 2015, 05:53:58 AM
Confused!! Looking at the manual it says the opening shim should be .05-.15 and closing .00-.20? What???

ducpainter

#1
July 02, 2015, 06:58:05 AM
What don't you get?
"Once you accept that a child on the autistic spectrum experiences the world in
 a completely different way than you, you will be open to understand how that
 perspective
    is even more amazing than yours."
    To realize the value of nine  months:
    Ask a mother who gave birth to a stillborn.
"Don't piss off old people The older we get, the less 'Life in Prison' is a deterrent."


fragile_this_side_up

#2
July 02, 2015, 07:31:08 AM
The .00-.20.. I feel like .00 is a little, i dunno, tight? .10-.15 is understandable for the opening gap.

ducpainter

#3
July 02, 2015, 07:44:17 AM
Well first of all those dimensions are in mm.

The 2V Ducs run best with the closer set as close to zero as possible without causing drag on the cam when rotated by hand.

If you remove the belts you can feel the drag if you get it too tight.
"Once you accept that a child on the autistic spectrum experiences the world in
 a completely different way than you, you will be open to understand how that
 perspective
    is even more amazing than yours."
    To realize the value of nine  months:
    Ask a mother who gave birth to a stillborn.
"Don't piss off old people The older we get, the less 'Life in Prison' is a deterrent."


fragile_this_side_up

#4
July 02, 2015, 08:52:17 AM
OK. thanks for the clarification. yes, i know in MM. SO LITTLE PLAY!! first timer here, so i'm just making sure i don't mess it up.. thanks so much for the clarification.

Print
Go Up Pages1
User actions