upper clamp pins - help with mount

[Pleh]

guys, can someone help me with this f*****g thing ... I got used upper triple clamp, but it is missing lower pins that hold air pressure sensor. I ordered the pins but the diameter is smaller then the hole ... I was able to find old and destroyed clamp and I saw that these pins are somehow widened ... does anyone know how to set put them in place?

[stopintime]

You can put the sensor anywhere, by the use of zip ties.

Your picture service forces me to accept privacy violations OR spend forever to deny (still just) a small part of them.

Will you consider using a service with "forum hot link"?

[Pleh]

You can put the sensor anywhere, by the use of zip ties.

Your picture service forces me to accept privacy violations OR spend forever to deny (still just) a small part of them.

Will you consider using a service with "forum hot link"?

where do you usually upload photos?

[stopintime]

I use Postimage.org

https://postimg.cc/files

I choose album, picture, share button and Hotlink for forums

(Remember to make albums from the start)

[Pleh]

[stopintime]

Ok - they are the locating pins (dowels?) for the U-bracket. Sensor is not related. If you have the correct size, it's about forceful twist, turn, push and pull.

[Pleh]

I ordered two of them from official Ducati shop, with VIN number, and the diameter is smaller then the hole ... they seem like rolled piece of metal, so I am thinking there is a way to put them inside the hole and then spread them somehow

I mentioned the sensor pecause U backet is the one that it mounts on.

[stopintime]

, so your second hand upper triple has a different diameter hole? I'd think there are correct diameter pins to be bought - dosn't have to be Ducati.

If you end up drilling/widening the hole.... make sure you stop half way since the rubber vibration damper is screwed down into the upper half.

[ducpainter]

Those are standard coiled spring pins. Measure the hole in  mm and head to the hardware store.

If you can't find the coiled variety a regular roll/spring pin will work.

[Pleh]

Thank you all for help, tomorrow I will try to fix that.